Comparative Evaluation of Commercial Iron Oxide Particles for Magnetic Particle Imaging Using Relaxometry and Image-Based Metrics

Abstract

In magnetic particle imaging (MPI), signal is generated from the non-linear magnetic response of superparamagnetic iron oxide (SPIO) nanoparticles. The optimization of SPIOs for MPI is an active area of investigation. Tracer performance can be evaluated by magnetic particle relaxometry (MPR) and image-based metrics. This study characterized and compared the performance of ten commercially available tracers, spanning a broad range of magnetic core sizes, hydrodynamic diameters and surface coatings, using the peak signal intensity measured from MPR, and the total signal and maximum signal intensity measured from 2D MPI images. Synomag-D tracers exhibited the highest MPR peak signal intensities and highest maximum signal per {micro}g iron. ProMag, a micron-sized iron oxide particle (MPIO), yielded a low MPR peak signal intensity but had the highest total MPI signal per {micro}g of iron. A strong correlation was observed between MPR peak signal intensity and MPI maximum signal intensity (R2=0.94). In contrast, there was a weak correlation between MPR peak signal intensity and MPI total signal intensity (R2=0.38), though this correlation improved when MPIOs were excluded from the analysis (R2=0.91). While MPR generally predicts the tracer performance, it does not completely replicate the complex imaging conditions. As such, comprehensive tracer evaluation requires combining both MPR and image-based metrics.