Influence of Non-Specific Surface Adhesion on the Shape and Microrheology of Red Blood Cells

Poly-L-Lysine (PLL) mediates the non-specific adhesion of cells and is commonly used in Atomic Force Microscopy (AFM) measurements, to ensure that cells remain attached to the substrate. However, it is acknowledged that adhesion affects the measured mechanical properties, in particular in the case Red Blood Cells (RBCs). This results in a wide range of Youngs modulus E reported in the literature. The present study aims at providing a systematic approach to the impact of non-specific adhesion on the rheology of RBCs. It provides a correlation between the topography profile of adherent RBCs and their rheology, from weak (cPLL = 10-3 mg/mL) to strong-adhesion (cPLL = 100 mg/mL) regimes. Using RICM and AFM, we find that there is a continuum of RBC shapes promoted by adhesion, from concave to dome-shaped, as predicted by the theory of vesicle adhesion. Their elastic properties discriminate them into two populations depending on adhesion strength, where stiffer RBCs (E {gtrsim} 100 Pa) correlate with dome-shaped cells. These findings are supported by rheology measurements of the dynamic complex shear modulus G*(f): while the storage modulus increases with cell-substrate adhesion, reflective of an increased membrane shear modulus, the loss modulus remains unchanged. Finally, further analysis inspired by membrane theory shows that different deformation modes may be triggered during indentation of either weakly or strongly adhering RBCs, illustrating the limits of the Hertz model.