TailTimer: an open-source device for automating the rodent tail immersion assay

The tail immersion assay is a widely used method for measuring acute thermal pain in a way which is quantifiable and reproducible. It is non-invasive and measures response to a stimulus that may be encountered by an animal in its natural environment. However, tail withdrawal latency data are usually collected manually, and precise temperatures of the water at the time of measurement are most often not recorded. These two factors can reduce the reproducibility of tail immersion assay data. We designed a device, TailTimer, which uses the Raspberry Pi single-board computer and a temperature sensor, to automatically record both tail withdrawal latency and water temperature. The device has a radio frequency identification (RFID) system that can record the ID of animals. Our software recognizes several specific RFID keys as user interface commands, which allows TailTimer to be operated via RFID fobs. We also programmed the device to only allow tests to be conducted when the water is within {+/-} 0.25 {degrees}C of the target temperature. Data recorded using the TailTimer device showed a linear relationship between tail withdrawal latency and water temperature when tested between 47 - 50 {degrees}C. We also observed a profound effect of water mixing speed on tail withdrawal latency. Our data further revealed significant strain and sex differences, valorizing TailTimer in its ability to detect genetically-determined variations in thermal pain sensitivity. Significance StatementQuantification of tail withdrawal latency in response to thermal pain has essentially remained the same since the method was first introduced decades ago and relies on manual recording of water temperature and tail withdrawal latency. Such manual methods engender relatively substantial variability and are potential contributors to some of the discrepancies present among relevant research. The open source TailTimer device we report here is simple and inexpensive to manufacture. The RFID-based user interface is ergonomic, especially in animal facilities where space is limited and gloves are mandatory. We anticipate that the increased reproducibility of tail withdrawal latency provided by TailTimer will augment its utility in nociception and addiction research.